Daniel White Important Guide To Keep To When You Are Searching For Sprinkler Systems
Measure the water pressure at an outside faucet along with a water pressure gauge, then time how long that it takes to fill a 5-gal. bucket to determine flow.
Produce a scale drawing of your property, including plantings and different features. Send the drawing together with the results of Step one to your irrigation company. It’ll produce a system set up applicable for your climate and needs, and can provide you with the parts and tools necessary to put it in. Several firms give this service free; others charge a modest fee. Run your pipe according to the plan. You don’t need to dig a trench–you can use a motorized pipe puller to drag polyethylene pipe thru the bottom with minimal disturbance. During this case, wrap the low-voltage zone valve management cable around the pipe and pull it at the same time.
If you dig a trench, either with a trench digger or manually, make it 8 to 10 inches deep, Dig the most important runs, then the branch lines. Connect your pipe to the household water supply by running a copper pipe to the outside of the house at ground level. Install a ball valve and a backflow preventer between the supply and the outlet to confirm that no polluted water can get back into the source from your lawn or plantings; this also allows you to shut off the supply to irrigation system while not shutting off the water to the house. Place a screw fitting on the surface end of the copper pipe plus begin your plastic pipe run there. If your system has multiple zones, assemble the valves and then connect them to the pipes below ground level. Wire the valves according to the manufacturer’s directions. Put a valve box over the zone valves and fill around it with top soil. The box cover must be level or just below the surface. Discover more about sprinkler systems here.
Attach the polyethylene pipe using barb fittings, securing the pipe with stainless-steel crimp rings. Install brass drain valves if you will have to drain the system at the low points of the pipes. Dig holes of sufficient size to fit sprinkler heads plus to make connections from the pipe. If you are irrigating different sorts of vegetation, your provider can likely have provided more than just one kind of head. Attach sprinkler heads employing a 90-degree ell fitting, or if you need drainage, a drainage ell. Attach the ell to the sprinkler head following the irrigation company’s instructions. Backfill around the heads, tamping the soil while you go. Use a mallet to make it firm. Attach the cable for the zone valves to the control box, always following the manufacturer’s directions.
